PureWashPro PUREWASH PRO Bedienungshandbuch PDF herunterladen (Seite 8)

INSTALLATION

1. The pureWash should be fastened to the wall, just above and behind your washing

machine. It is recommended that one of the mounting holes on the pureWash be

mounted to a wall stud, if possible. One set of mounting screws are included. If it is not

possible to mount the pureWash to a wall stud, you should use “molly” type expandable

screw anchors, available at your local hardware store. For any other type of mounting

scenarios (concrete block, etc.) please consult your local hardware store for assistance.

2. Place your Mounting Bracket onto the wall with the tabs facing up and away from the

wall, making sure it is level, mark the locations of the screw holes. If necessary, pre-drill

your holes and use the supplied Wall Anchors. Fasten the Mounting Bracket to wall

using the supplied screws.

3. Place your pureWash against the wall and gently slide the unit down into the lock

position of the mounting bracket slots.

4. Connect the cold water hose from your washer to the “To Washing Machine” tting

on your pureWash. Check that the rubber washer in the hose is in place and properly

tighten the hose, but DO NOT overtighten. Use a wrench to hold the hose bib secure

while tightening the hose connection.

5. With the supplied hose, connect the “Cold Water In” tting on the pureWash to your

Cold Water Supply Faucet. Make sure rubber washers are in place and properly

tighten, but DO NOT overtighten. Again, use a wrench to hold the hose bib secure on

the pureWash while tightening.

6. Plug the power adapter into the DC adapter plug-in on the right side of your pureWash

and then plug the adapter into a wall outlet.

7. Ensure all hoses are properly installed and tightened, and that the power supply has

been properly installed. SLOWLY turn the water supply back on and check for any leaks

or drips. Gently tighten ttings if leaks are apparent, but DO NOT overtighten.

CAUTION: The hot water hose should not be disconnected from the washer. You can

turn off the hot water or leave it on, but the hose must be installed to the washing

machine to prevent backflow of water out of the washing machine during use.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

PureWashPro PUREWASH PRO Bedienungshandbuch Seite 8